A0 Silver Snap Frame

More about these popular silver snap frames with square corners

• 25mm refers to the width of the snap frame surround.  This is the part which opens up to gain access to the contents and the fixing holes. 
• Mitre corners, also known as square corners, means that the corners are cut at a 45 degree angle such that the two profiles butt perfectly together. Precision manufacturing ensures the mitre joints close correctly without an unsightly gap.  
  This is provided that printed paper or thin card inserts are used and the poster size accurately matches the frame size.

Clip frames

Snap frames are sometimes called clip frames, not to be confused with the domestic type of poster frame with a hardboard back and clips around the perimeter. You may have searched for clip frames, snap picture frames or trappa frames because the aluminium profile traps the edge of the poster securely.

Size Information for A0 aluminium snap frames

• The overall frame size is 870mm x 1217mm
• The width of the surround is 2.5cm = 25mm or 1 inch
• Front to back depth of 25mm profile snap frame: 12mm (approx 1/2 inch)
• A narrow strip around the edge of your print is hidden when the frame is closed.
  Visible poster size: 22mm less than actual poster (i.e. 11mm all round your poster is hidden by the frame surround) 

Fix snap frames using screws

• The best way to permanently fix snap frame is with screws.
• Screws and plastic wall plugs are included with every snap frame we supply
• The wall plugs are for use with masonry walls such as brick and most plastered walls 
• When screwing onto wood the plugs are not needed 
• A power drill and screwdriver are required for screw fixing (and we recommend using a spirit level and tape measure to ensure the frames are properly aligned). If in doubt please consult a proficient DIY or trades person.

Fix snap frames using adhesive tape

• Rolls of double-side adhesive tape are available as an accessory item.
• If double-side adhesive tape is used to fix frames (in place of the screws supplied) please check the smoothness and suitability of the wall.
• Tiles and similar surfaces may be suitable provided they are cleaned thoroughly before application.
• Tape fixing is not suitable for surfaces with a non-stick coating or porous/foamed surfaces. 
• We recommend that tape is used around the full perimeter of the frame.
• Larger frames are normally best screwed. A residue of foam tape will be left on the wall or door after removal of the frame and the frame will usually be hard to get off.