Poster light boxes for hanging

LED Illumination has many advantages.

• LED is the longest life light souce (no tubes to change every year or two) with the lowest running costs.
• These valuable features are combined with bright illumination, cool running, excellent reliability and no maintenance for up to 100,000 hours.
• The life cost of LED (light emitting diode) light boxes is significantly lower than other light boxes because of the energy efficiency factor.
• The environmental advantages of lower energy use represent a persuasive argument. 
• The Power Supply Unit (PSU) supplied is rated for operation up to 16 hours per day - a daily recovery time is required to achieve long life of the PSU.

Lightbox has an on/off switch located on the bottom edge (caution not to damge this while installing - e.g. by resting the light box on the switch).

Lightweight design makes hanging easy in standard situations.  Additional supension components are available for special situations.

CE listed electrical components and all units are CE/UL PAT tested. 
Each lightbox is supplied with Quality Compliance Certificates.

Dimensions of the available sizes are as follows:
Dimensions are stated as Width x Height when the frame is presented in a portrait orientation. 

Ceiling fixings are included

Two adjustable length hanging wires are supplied together with screw-on ceiling fixings (see below). A 13A socket needs to be accessible, often installed at high level or in the ceiling void, connected to a circuit which is controlled by a time clock or can be switched off from an accessible location.

Landscape display

For landscape display the two suspension wires need to be re-threaded through holes provided in the long edge of the frame as the menu light box is configured for portrait display when delivered.

How to hand the light box from a conventional ceiling

The suspended light box comes with 2m drop wires (excess wire can be discarded) plus ceiling anchors for screwing onto the ceiling or for locking onto conventional grid ceilings.

First thread the suspension wires up through the suspension hole in the the clear plastic hangers until it comes to the stop end.

To adjust the length of the drop you require, use the 'cable terminator' fitting on the plain end of the wire.

Tighten using the supplied allen key.

Screw the ceiling mounts onto the ceiling using the plugs and screws supplied.

Screw up the bullet cover to support the wire.

Upgrade to fittings which are easier to adjust with suspended ceiling option

Alternatively order these components to suit either a conventional flat ceiling or a suspended ceiling as they will make adjusting the height easier.